Lora Wireless Irrigation Controller 4 Station Field Controller 5km
Wireless On Off Control
Product features:
1. Controller is solar powered.
2. Only need one key push to setup Dry/Wet control threshold. Very
easy to use.
3. Has manual key to manually open/close valves for the convenience
of field operation and maintain.
4. With pressure meter installed to check valve open/close
abnormal, alarm to main controller if there is failure.
5. This controller also function as relay. The built in
bidirectional wireless distance can reach 2000m through mesh
network.
6. The moisture sensor can bury deep in the soil.
7. If there is not enough solar power, the controller will turn off
valve first, then turn self-off, recharging , and wake up
automatically after recharged.
8. Field controllers in the range will automatically setup mesh
network route to communicate with main controller.
9. This controller can work for almost one month under rain/cloudy
days.
Specifications:
Solar panels: 17.4V DC /220mA/3.8W
Back-up battery: 10*1.2V/ 2.3AH AA Size
Quiescent current: 1mA
Frequency: 902-928 MHZ
Communication distance at open space: 1600ft
Working environment: Temperature [-30~60℃]; Humidity [<90%]
Lasting time of fully charged battery: 7 days without sun
Battery charging time: 10 hours under standard illumination
Moisture sensor:
1, Output: pulse signal
2, Moisture Range: 0-99%
3, Precision: 1%
4. Sample soil moisture frequency:
A. Push scan key immediately take sample, normally take soil sample
every 5 minutes under irrigation, otherwise 30 minutes.
B. When exit from setup, controller will take sample once.
C. When at adjusting Dry/Wet control menu, take sample every 0.5
second.
Solenoid valve:
1, Output: pulse signal
2, DC6-12V
Pressure Meter:
1, Pressure range:0.06Mpa-0.6Mpa; 0.1Mpa-1.3Mpa
2, Thread:1/2,1/4,1/8 NPT can be choosed.
| Parameter |
| Power output: | 1W |
| Power supply: | 12.6V AC |
| Control distance: | 5km LOS |
| Baud rate: | 2400bps |
| Receiving sensibility: | -123dBm@1200bps, -118dbm(9600bps) |
| Networking |
| Networking: | Point to point and point to multipoint |
| Protocol: | Modbus RTU protocol |
| Port Description |
| Input | 8 active inputs (passive customize), isolated |
| Output: |
2 relay output |
| Communication port | TTL |
| Current |
| Transmit current: | <400mA |
| Receiving current: | <40mA |
| General |
| Frequency: | 433MHz |
| Channel No: | 16 channels, can change via DIP switch |
| Physical Properties |
| Dimension: | 115×90×40(mm) |
| Antenna Connector: | SMA,vehicle antenna with 1.5m cable |
| Temperature: | -35℃~+75℃( industrial) |
| Mounting method: | Standard 3.5 inch industrial guild rail |
How to wire
Installation at field
